互花米草入侵对长江口湿地土壤碳动态的影响

为了评价互花米草入侵对长江河口湿地土壤碳动态的影响,利用配对的试验设计在长江口崇明东滩湿地的高潮滩和低潮滩各设置1条入侵种互花米草与土著种的配对样线.结果表明,与土著植物相比,互花米草入侵显著增加了长江口湿地的植物碳库、土壤微生物碳、土壤总碳库和有机碳库,而对占土壤总碳库60%以上的无机碳库无显著影响,意味着互花米草入侵导致的土壤总碳库改变主要是通过增加土壤有机碳库来实现的.高潮滩互花米草和芦苇群落的年均土壤呼吸强度分别为（210.02±4.90）,（157.79±6.39）mg/（m²·h）;低潮滩互花米草和海三棱藨草群落年均土壤CO₂排放速率分别为（157.41±5.27）,（110.90±5.16）mg/（m²·h）,表明互花米草入侵显著增加长江口湿地的土壤呼吸.上述结果意味着互花米草入侵同时增加土壤碳输入和碳输出,但入侵也显著增加了土壤碳库表明入侵增加的土壤碳输入显著高于增加的土壤碳输出.本研究表明互花米草入侵可能会增强了长江河口湿地的土壤碳汇强度和固碳能力.但仍然需要长期系统的监测研究,以便全面定量评估互花米草入侵我国滨海湿地的综合生态影响.     

Potential of secondary aerosol formation from Chinese gasoline engine exhaust

Light-duty gasoline vehicles have drawn public attention in China due to their significant primary emissions of particulate matter and volatile organic compounds(VOCs). However,little information on secondary aerosol formation from exhaust for Chinese vehicles and fuel conditions is available. In this study, chamber experiments were conducted to quantify the potential of secondary aerosol formation from the exhaust of a port fuel injection gasoline engine. The engine and fuel used are common in the Chinese market, and the fuel satisfies the China V gasoline fuel standard. Substantial secondary aerosol formation was observed during a 4–5 hr simulation, which was estimated to represent more than 10 days of equivalent atmospheric photo-oxidation in Beijing. As a consequence, the extreme case secondary organic aerosol(SOA) production was 426 ± 85 mg/kg-fuel, with high levels of precursors and OH exposure. The low hygroscopicity of the aerosols formed inside the chamber suggests that SOA was the dominant chemical composition. Fourteen percent of SOA measured in the chamber experiments could be explained through the oxidation of speciated single-ring aromatics. Unspeciated precursors, such as intermediate-volatility organic compounds and semi-volatile organic compounds, might be significant for SOA formation from gasoline VOCs. We concluded that reductions of emissions of aerosol precursor gases from vehicles are essential to mediate pollution in China.     

The effects of autophagy on vascular endothelial cells induced by airborne PM2.5

The purpose of this study was to examine the direct toxicity of PM2.5 collected from Beijing on human umbilical vein endothelial cells(HUVEC). A Cell Counting Kit 8(CCK8) assay demonstrated that PM2.5 exposure decreased the proliferation of HUVECs in a dosedependent manner. We also found that PM2.5 exposure induced autophagy in HUVECs, as evidenced by:(1) an increased number of double-membrane vesicles;(2) enhanced conversion and punctuation of the microtubule-associated protein light chain 3(LC3); and(3) decreased levels of the selective autophagy substrate p62 in a time-dependent manner.Furthermore, promoting autophagy in PM2.5-exposed HUVECs with rapamycin increased the cell survival rate, whereas inhibiting autophagy via 3-methyladenine significantly decreased cell survival. These results demonstrate that PM2.5 exposure can induce cytotoxicity and autophagy in HUVECs and that autophagy play a protective role against PM2.5-induced cytotoxicity. The findings of the present study imply a direct toxic effect of PM2.5 on HUVECs and provide novel insight into the mechanism of cardiovascular diseases caused by PM2.5 exposure.     

Mercury flows in large-scale gold production and implications for Hg pollution control

Large-scale gold production(LSGP) is one of the five convention-related atmospheric mercury(Hg) emission sources in the Minamata Convention on Mercury. However, field experiments on Hg flows of the whole process of LSGP are limited. To identify the atmospheric Hg emission points and understand Hg emission characteristics of LSGP, Hg flows in two gold smelters were studied. Overall atmospheric Hg emissions accounted for 10%–17% of total Hg outputs and the Hg emission factors for all processes were 7.6–9.6 kg/ton. There were three dominant atmospheric Hg emission points in the studied gold smelters, including the exhaust gas of the roasting process, exhaust gas from the environmental fog collection stack and exhaust gas from the converter of the refining process. Atmospheric Hg emissions from the roasting process only accounted for 16%–29% of total emissions and the rest were emitted from the refining process. The overall Hg speciation profile(gaseous elemental Hg/gaseous oxidized Hg/particulate-bound Hg) for LSGP was 34.1/57.1/8.8. The dominant Hg output byproducts included waste acid, sulfuric acid and cyanide leaching residue. Total Hg outputs from these three byproducts were 80% in smelter A and 84% in smelter B. Our study indicated that previous atmospheric Hg emissions from large-scale gold production might have been overestimated.Hg emission control in LSGP is not especially urgent in China compared to other significant emission sources(e.g., cement plants). Instead, LSGP is a potential Hg release source due to the high Hg output proportions to acid and sludge.     

Relationship between physicochemical properties and dewaterability of hydrothermal sludge derived from different source

Sewage sludge (SS) and deinking sludge (DS) were used to comparatively study the hydrothermal dewatering of sludge with different components. For a better overview, an insight into the relationship between physicochemical properties and dewaterability of hydrothermal sludge was provided. Results found that not all kinds of sludge were suitably conditioned by hydrothermal treatment (HT) in term of the elevation of dewaterability. Higher hydrothermal temperature tended to enhance the dewaterability of SS rather than DS, which was supported by the variation of their physicochemical properties (including water distribution, bonding energy, extracellular polymeric substance (EPS), particles size, acid functional groups and zeta potential in this study). In addition, the changes in surface morphology suggested that the reverse effect of HT on sludge dewaterability was mainly due to their dewatering behavior. For SS, the destruction of EPS structure leaded to the release of bound water, thereby strengthening sludge dewatering. Conversely, “Bridging effect” generated by lignocellulose in DS was beneficial for sludge dewatering; however, the increasing hydrothermal temperature degraded part of lignocellulose and weakened “bridging effect”, finally resulting in worse dewaterability of DS.     

Investigating the bacterial community and amoebae population in rural domestic wastewater reclamation for irrigation

Reclamation of domestic wastewater for agricultural irrigation is viewed as a sustainable option to create an alternative water source and address water scarcity. Free-living amoebae(FLA), which are amphizoic protozoa, are widely distributed in various environmental sources. The FLA could cause considerable environmental and health risks. However, little information is available on the risk of these protozoa. In this study, we evaluated the feasibility using rural domestic wastewater for agricultural irrigation, and analyzed dynamic changes of the microbial community structure and FLA populations in raw and treated wastewater, as well as the phyllosphere and rhizosphere of lettuce production sites that were irrigated with different water sources. The bacterial community dynamics were analyzed by terminal restriction fragment length polymorphism(T-RFLP). The bacterial community structures in the influent were similar to that in the effluent, while in some cases relative abundances varied significantly. The populations of Acanthamoeba spp. and Hartmannella vermiformis in the anaerobically treated wastewater were significantly higher than in the raw wastewater. The vegetables could harbor diverse amoebae, and the abundances of Acanthamoeba spp. and H. vermiformis in the rhizosphere were significantly higher than in the phyllosphere. Accordingly, our studies show insight into the distribution and dissemination of amoebae in wastewater treatment and irrigation practices.     

Seasonal variation and size distribution of biogenic secondary organic aerosols at urban and continental background sites of China

Size-resolved biogenic secondary organic aerosols(BSOA) derived from isoprene and monoterpene photooxidation in Qinghai Lake, Tibetan Plateau(a continental background site) and five cities of China were measured using gas chromatography/mass spectrometry(GC/MS). Concentrations of the determined BSOA are higher in the cities than in the background and are also higher in summer than in winter. Moreover, strong positive correlations(R2= 0.44–0.90) between BSOA and sulfate were found at the six sites,suggesting that anthropogenic pollution(i.e., sulfate) could enhance SOA formation,because sulfate provides a surface favorable for acid-catalyzed formation of BSOA. Size distribution measurements showed that most of the determined SOA tracers are enriched in the fine mode( 3.3 μm) except for cis-pinic and cis-pinonic acids, both presented a comparable mass in the fine and coarse( 3.3 μm) modes, respectively. Mass ratio of oxidation products derived from isoprene to those from monoterpene in the five urban regions during summer are much less than those in Qinghai Lake region. In addition, in the five urban regions relative abundances of monoterpene oxidation products to SOA are much higher than those of isoprene. Such phenomena suggest that BSOA derived from monoterpenes are more abundant than those from isoprene in Chinese urban areas.     

反舰导弹命中精度预测与评估

目的解决反舰导弹命中精度受试验航区及靶场试验环境等客观条件制约,难以通过飞行试验得到客观全面评估的问题。方法在对影响反舰导弹命中精度的主要因素进行分析的基础上,利用实际环境条件下的飞行试验数据,构建基于偏最小二乘回归的命中精度模型,实现对反舰导弹各种使用环境条件命中精度的定量评估。结果在构建基于偏最小二乘回归的命中精度模型后,可以实现对90°发射扇面角、20 m/s侧风以及300 km最大射程等实际试验无法考核的边界使用环境条件下反舰导弹的命中精度进行定量评估。结论通过实例分析表明了方法的有效性和可行性,可以实现有小样本条件下对反舰导弹命中精度的评估。     

增压站低频噪声识别与控制

目的解决天然气增压站低频噪声严重的问题,识别低频噪声源,并对低频噪声加以控制。方法结合压缩机组的实际工作情况及结构,首先利用频谱及1/3倍频程分析增压站机组的振动和噪声特性,初步确定压缩站机组低频噪声与机组振动的关系,进一步利用相干函数分析法分析振动与低频噪声的相干关系,判定低频噪声并不是由振动主要引起的。结果机组的主要噪声源为冷却器和压缩缸的进排气管,低频噪声污染主要是由于机组周期性吸排气时,管道和机组壁投射出的空气动力性噪声所造成的,而机组振源的剧烈振动不是产生低频噪声污染的主要原因。进排气管可产生高达80 d B(A)的全频带噪声,其中包含声压级可高达100 dB的次声,尤其以频率11 Hz和17 Hz为主,并且传播距离远,通透力强,对人员和环境危害大。结论首先依据进排气管为主要噪声源,其次结合压缩站实际情况,从压缩器机组整体的降噪设计及厂房治理的降噪设计两部分考虑提出相应的改进措施,从而为机组的降噪提供有效的方法。     

基于有限元分析的橡胶减振器优化设计

目的加快橡胶减振器的设计过程。方法分析橡胶材料及Mooney-Rivllin橡胶本构模型特点,介绍橡胶减振器应用特点及隔振设计的相关理论,采用Mooney-Rivllin模型模拟橡胶材料的力学特性,通过引进有限元优化技术,在设计初期保证减振器的刚度特性。结果在某设备减振设计中,采用单轴拉压曲线获取了橡胶材料的Mooney-Rivllin模型参数,以减振器的部分结构尺寸为设计参数,减振器的三向刚度为设计目标,获取了三轴向频率近似相等的隔振系统(轴向频率40 Hz、径向频率40.9 Hz)。通过试验测试,减振系统频率与试验值差别较小,其中轴向差别为2%,径向差别为1%。结论通过引进有限元优化技术,采用合理的橡胶本构模型,可以满足工程精度要求,加速了橡胶减振器的设计过程。